Trinity Subsurface scans concrete slabs, walls, decks and columns with ground penetrating radar before you core, saw cut or anchor. Technicians locate rebar, post-tension cable, electrical conduit and voids, mark them directly on the surface, and leave a field sketch so the cutting crew knows exactly where it is safe to drill. GPR uses no radiation, so hospitals, labs, offices and classrooms can stay occupied while we work.
We cover the District of Columbia, Northern Virginia and Montgomery and Prince George's counties in Maryland, including federal and institutional buildings. Call (855) 387-4648 to schedule.
Scanned the ceiling slab beneath a parking garage to map post-tension cables and other embedded features.
Cleared seven coring locations 10 to 12 feet overhead, scanned from a lift.
Located epoxy-coated rebar in an existing slab and waterproofing so new anchors could be offset around it.
Scanned three wall locations and a slab over the parking garage, from both sides, before ductwork penetrations.
About 80 scan locations across 10 floors to designate post-tension cables before 4-inch anchor bolts were installed.
Yes. GPR uses low-power radio waves instead of radiation, so nobody has to clear the floor and the work can happen during normal hours. Results are marked on the surface the same day.
Yes. Post-tension tendons, rebar and conduit all show up on GPR. On post-tensioned decks we mark tendons and leave clear zones for coring or anchoring.
Most requests are on site within three business days, often sooner. Call (855) 387-4648 and scheduling will confirm what is possible, including any building access or escort requirements.
Yes. Trinity Subsurface also provides concrete core drilling, so one mobilization can cover both. See our concrete scanning service for more detail.